Correct installation, use and maintenance of the reducer, an important part is to ensure the normal operation of mechanical equipment. You install NEUGART planetary reducer sure in strict accordance with the following installation related matters seriously assembly and use.
The first step is to install before confirmation motor and reducer are intact, and strictly check whether the size of each part of the motor and reducer connected matching motor positioning boss, the input shaft reducer groove size and tie tolerances.
The second step is to unscrew the reducer flange on the outside dust-hole screw clamping ring to its side of the hole and the dust-hole alignment, adjust the PCS system, insert Hexagon tighten. After removal of the motor shaft key.
The third step is naturally connected to the motor and reducer. Must ensure that the output shaft of the reducer and motor input shaft concentricity consistent, and both the outside flange parallel connection. As inconsistent centrality, will lead to the break of the motor shaft reducer gear wear.
In addition, installation is strictly prohibited with a hammer, hitting, to prevent the axial force, radial force excessive damage to the bearing or gear. Be sure to install the bolts tightened and then screwed tightly to force the bolt. Before installation, the motor input shaft positioning bosses and anti-rust oil reducer joints wipe net sodium and water use gasoline or zinc. Its purpose is to ensure that the connection tightness and operation flexibility, and to prevent unnecessary wear. Before connecting the motor and reducer, please the vertical keyway of the motor shaft tensioning bolts. In order to ensure uniform force, please be on any mounting bolts spin angular position, but do not tighten the spin on the last one by one of two pairs of the angular position of the mounting bolts tighten the four mounting bolts. Finally, the spin tightly force the bolt. All tensioning bolts are required to use a torque wrench fixed torsional moment data indicated fixed and inspected. The right-angle gearhead related data with the same model straight reducer is not exactly the same, also requested the user's attention. * The correct reducer and mechanical equipment installed similar deceleration machine with the drive motor is installed correctly. The key must ensure reducer output shaft driven shaft concentricity.
Conclusion With the continuous deepening of the global industrial development, planetary reducer in drive more and more obvious. I hope in the future use of the process of planetary reducer can bring you more convenient and affordable!