Gear reducer is generally used for low-speed high-torque transmission equipment. The motor, internal combustion engine or other high-speed power is passed through the gear with a small number of teeth on the input shaft of the gear reducer to the gear on the output shaft to achieve the purpose of reduction. But during the running process, the transmission is not stable, so what is the reason for the uneven transmission of the gear reducer? The following gear reducer manufacturer Weigao Transmission has found the reason for you.
The maximum temperature of the gear reducer under normal working conditions should not be higher than 45 degrees Celsius. If high temperature occurs, you should immediately obstruct the rigid inspection. The same general reason for this problem is that the gear reducer of this tonnage is selected to have a small overload sign, or a worm and The worm gear end cap is pressed into a high temperature environment that is too tight, and the input speed is not eliminated. The outer worm gear reducer is greased. The maximum speed of the worm shaft must not exceed 1000min / s. If the input speed is too high, a high position and a card death will occur. In other environments, the punishment for high temperature is to lose the input speed, check whether the embedding of the gland is too tight, and whether the planetary gear reducer is short of oil.
After understanding the gear reducer manufacturer Xiaobian, I look forward to assisting you.
The reasons for the tremors that occur after the additional load in the application process are the uneven lead screw pitch, the uneven split of the gear reducer worm, the unqualified quality of the flat pressure bearing and the taper bearing, and the upper and lower sheaths of the lead screw are too tight together.
Assume that your gear reducer has an unstable transmission during the running process. I believe that you will know the root cause and solution after reading the above content.
