The failure scenarios Failure solution

And overload to adjust to the appropriate load
Too little or too much lubricant follow the instructions to join the right amount of lubricant
After adding the appropriate lubricant reducer overheating lubricants bad or inappropriate oil discharge
Oil seal excessive friction in the oil seal at a few drops of lubricant
Connected to the output shaft and the gear improperly adjusted to the appropriate location

Worm, worm tooth contact surface meshing bad dresser
Bearing damage or replace the bearing gap is too large
The oil shortage reducer murmur adding an appropriate amount of lubricating oil in accordance with the instructions
Foreign body penetrated the removal of the foreign body and replacement of oil

Transmission fixed bad transmission fixed
Replace the worm gear worm gear wear or damage
Abnormal vibration bearing wear or damage replace the bearings
The bolts loosening of the locking bolt
Foreign body penetrated removal of the foreign body and replacement of oil

Replace oil seal oil seal damage
Forced to shut breakage replacement packing
Adding an appropriate amount of lubricating oil as instructed excessive oil spill oil
Drain bolt is loose drain plug
The damage to the oil immersion lens replacement oil immersion

Replacement worm gear or worm worm overheating expansion
Bearing damage replace the bearings
Into force or the output shaft does not turn the foreign body penetrated foreign body removal and replacement of oil
Worm, worm excessive wear replacement worm gear or worm

Overload adjusted to the appropriate load
The lubricants adverse or inappropriate replacement of appropriate lubricants
Worm excessive wear lubricants adding an appropriate amount of lubricating oil in accordance with the instructions
Replacement of bearings bearing wear
High operating temperatures improve ventilation environment